NX-148E
ARMING IN “EXIT” MODE EXIT is used when the user is away from the premises
and wants the interior protected (the motion detectors ON).
ARMING IN “STAY” MODE STAY is used when the user is inside the premises and
wants protection around the perimeter (the motion
DISARMING SYSTEM Enter code.
user code, enter * * * * for a 4-digit code.
7. Press the “#” key while the ready light is flashing to
BYPASSING ZONES System must be in disarmed state.
2. Enter 1 or 2 digits indicating the zone you wish to
bypass. (Example: Press the “1” key for zone 1,
4. The corresponding zone light will illuminate indicating
the zone has been bypassed. Repeat steps #2 and #3 for
any other zone(s) that need to be bypassed.
5. Press the “#” key to exit the Bypass Mode. The bypass
light will stop flashing upon exiting the Bypass Mode.
All zones will automatically be unbypassed each time the
system is disarmed.
2. The ALARM MEMORY feature will flash those zones
that created alarms and will light steady those zones that
IDENTIFYING TROUBLES
FLASHING ARMED LIGHT The armed light will flash when there has been
an alarm during the previous arm cycle.
POWER LIGHT OFF No AC power.
POWER LIGHT FLASHING Low system battery.
FIRE LIGHT FLASHING Trouble with fire device or wiring.
ZONE LIGHT FLASHING RAPIDLY A zone is in a trouble condition.
SERVICE LIGHT IS ON Press “*2” for further information (indicated by
zone lights).
Zone 1 – System fault.
Zone 2 – Zone tamper.
Zone 5 – Zone trouble.
Zone 6 – Telephone trouble.
Zone 7 – Dialer failure.
Zone 8 – System lost time.
Enter “#” to exit mode.
ENTER CODE TO SILENCE TROUBLE BEEPS.
ENTER “*7” TO ATTEMPT TO RESET TROUBLES.
ENTER CODE TO CLEAR SERVICE LIGHT AFTER A PHONE TROUBLE HAS BEEN CLEARED.
SET CLOCK 1. Press “*97.”
