Silent Knight 2730 Operating Instructions

Enter access code. If green light is on, all zones will be protected. If green light is off and one or more of the zone lights are one, the zones in violation will not be protected.

When system has an alarm, disarm, check flashing light for zone that caused alarm. To re-set the violated zone, press the “shunt” key, then the “test” key.

To shunt one or more zones, press the “shunt” key and the number of the zone to be shunted. If more than one zone is to be shunted, repeat the above for each zone. This may be used when arming the system or using door chime.

After using door chime with shunted zones, it is necessary to unshunt each zone by pressing the “shunt” key and the zone number.  System automatically unshunts zones when disarming system.

A) When trouble light is on, the audible trouble tone has been silenced, and the wire has been cut.

Press the “shunt” key then the “0” code. Sound will stop, but light will stay on until trouble is repaired.

To summon the police and sound the sirens, press the “emergency” key.

A) When emergency light is on, there is trouble on the loop.

A) When fire light is on steady, there is trouble on the loop.

B) When fire light is flashing, the fire circuit is in alarm.

To change the delay door to instant, press the “instant” key before arming the system. Delay automatically returns upon disarming.

A) When yellow instant light is off, entry/exit is in effect on delay zone.

B) When yellow instant light is on, the entry/exit zone is now instant.

To activate the door chime, press the “door chime” key. To deactivate, press the “door chime” key again. To bypass any zone from chiming, see “Shunt a Zone” instructions. This key also activates any zone designated as interior. This zone will only be in operation when interior light is on.

A) When system is armed and the door chime light is on, it indicates the interior zones are on.

B) When system is disarmed and the door chime light is on, all zones other an interior zones will sound when violated and re-set.

Press the “9” key before entering access code to summon help without sounding sirens.

To change any or all access codes, press the “shunt” key, then the “test” key, then enter the “0” access code. The trouble light will flash. Enter each new code, pressing the “test” button after each one. If deleting one or more codes, enter the first number of the code then the “test” button. When completed, press the “test” key 3 times to exit program mode.

If wrong code is entered, stop, wait 5 seconds, then enter the correct code – or press the “test” key and enter the correct code.

The code beginning with 0 is the master code. This code will let you enter  programming to change operating codes and will let you use the test function.

Press the “test” key followed by your “0” code. All lights on keypad should light up, and sirens should sound briefly. System will send a test signal to central station.